Innovate-motorsports MTX-D, Boost/Shift Gauge Uživatelský manuál

MTX-D, Boost/Shift Gauge

- 10 - 5 Changing the MTX gauge face and/or bezel 1. Lay the MTX gauge face down and remove the three #2 phillips screws from the outside rim of

- 11 - Appendix A: Limited Warranty LIMITED WARRANTY Innovate stands behind the quality of its products. Innovate makes the following warranty to

- 12 - Revision History 1.0 – 4/5/2012 Initial release. 1.1 – 5/4/2012 Added addition screen shots and wiring diagram

- 2 - 1 Mounting and Sensor Installation... 3 1.1 Mount

- 3 - 1 Mounting and Sensor Installation 1.1 Mounting the Gauge The MTX Boost/Shift gauge fits in a standard 2-1/16” (52mm) hole. The gauge can b

- 4 - Circuits that share power with the vehicle’s stereo, ignition system, and fuel pump are not recommended. 2. Connect the main BLACK wire to

- 5 - Avoid connecting or disconnecting any of the ports labeled IN or OUT while the unit is powered ON. 3.1 Installing the LM Programmer Softwar

- 6 - 3.4 Pressure Tab 1. Display In allows the gauge to display Boost in either Imperial or Metric units of measure. 2. The Overboost Warning

- 7 - 3.5 RPM Tab 1. Mode: Select how many pulses per rotation based on your tach signal source 2. Scale: Select the RPM scale. Options are 102

- 8 - 1. Needle Bar RPM Config: You are able to select between Single Stage or Progressive shift light. Single Stage allows the gauge’s outer

- 9 - anticipate this occurring, it is possible that the MTX will not recover correctly and may need to be serviced at our factory. If you suspect t