Innovate-motorsports MTX-L Quick Start Guide Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Měřící nástroje Innovate-motorsports MTX-L Quick Start Guide. Innovate Motorsports MTX-L Quick Start Guide User Manual [de] [fr] [it] Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 2
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
MTX-L Accessories:
4 pin to 2.5mm daisy chain cable: #3812
4 pin to 4 pin daisy-chain cable: #3846
Exhaust Clamp: #3728
Stainless Steel Bung w/ Steel Plug” #3838
HBX-1: Heat-sinking Bung Extender: #3729
18ft sensor cable: #3828
Replacement Parts:
Bung/Plug set: #3764
Sensor (Bosch LSU4.2): #3737
4 pin Serial Programming Cable: #3840
8ft sensor cable: #3810
3ft sensor cable: #3843
Order parts, get support, find FAQ answers, and read case
studies at www.tuneyourengine.com
Warning!
1) The Oxygen Sensor used with this device gets very hot in
operation. Do not touch the hot sensor. Do not let a hot sensor
touch a combustible surface. Do not use the sensor with or near
flammable liquids or gases. Failure to heed these warnings may
result in severe burns, explosions or fires. 2) When installed in the
exhaust, the oxygen sensor MUST be connected and operating with
the MTX-L whenever the car is running. An un-powered oxygen
sensor will be quickly damaged when exposed to hot exhaust gases.
MTX-L (Digital Air/Fuel Ratio Gauge)
QUICK START GUIDE
The complete instruction manual is on the CD
Warning!
1) The Oxygen Sensor used with this device gets very hot in operation. Do not touch
the hot sensor or let a hot sensor touch a combustible surface. 2) When installed in
the exhaust, the oxygen sensor MUST be connected and operating with the MTX-L
whenever the car is running. An un-powered oxygen sensor will be quickly damaged.
11-0129
Zobrazit stránku 0
1 2

Shrnutí obsahu

Strany 1 - QUICK START GUIDE

MTX-L Accessories:  4 pin to 2.5mm daisy chain cable: #3812  4 pin to 4 pin daisy-chain cable: #3846  Exhaust Clamp: #3728  Stainless Steel

Strany 2 - Sensor Calibration

The complete instruction manual is on the CD MTX-L QUICK START GUIDE To gain access to the complete MTX-L manual please install the software provide

Komentáře k této Příručce

Žádné komentáře